Dell PowerVault TL1000 - Manual (Page 60)

v Validity - Enable/Disable setting.
v Trap version - v1, v2c, or v3. For v2c and v3, the Inform check box
determines whether an SNMP INFORM request is sent instead of a trap
event.
v IP address - IPv4 and IPv6 addresses are supported. Host names can be
entered instead of numerical IP addresses if the DNS server is specified.
v Community (v1 or v2c) - SNMP community name.
v User name (v3 only) - SNMPv3 unique user name.
v Authentication (v3 only) - Authentication algorithm, MD5, or SHA. When an
algorithm is specified, an authentication password and confirmation of the
password are required.
v Privacy (v3 only) - Privacy service encryption and decryption algorithm, DES
or AES. When an algorithm is specified, a privacy password and
confirmation of the password are required.
6. Enter the SNMPv3 users who are allowed to access the tape library in the
SNMPv3 User List
menu.
v Validity - Enable/Disable setting.
v User name - SNMPv3 unique user name.
v Authentication - Authentication algorithm, MD5, or SHA. When an
algorithm is specified, an authentication password and confirmation of the
password are required.
a29z0140
Figure 3-22. Trap list settings
a29z0141
Figure 3-23. SNMPv3 user list settings
3-22 Dell PowerVault TL1000 Tape Autoloader User's Guide