Dell PowerVault TL1000 - Manual (Page 160)

Table C-4. Ultrium Tape drive sense data - Bytes 12 and 13 (continued)
Byte 12 ASC Byte 13 ASCQ Description
EE 32 Encryption - Keystore Related Problem
EE 42 Encryption - EKM Challenge Pending
EE E2 Encryption - Key Translation Disallowed
EE FF Encryption - Security Prohibited Function
EF 01 Encryption - Key Service Not Configured
26 11 Encryption - Incomplete Key - Associate Data Set
26 12 Encryption (T10) - Vendor Specific Reference Key Not Found
55 08 Encryption (T10) - Maximum Number of Supplemental Keys Exceeded
Sense Key 6 (Unit Attention)
EE 12 Encryption - Key Change Detected
EE 18 Encryption - Changed (Read)
EE 19 Encryption - Changed (Write)
EE 40 Encryption - EKM Identifier Changed
EE 41 Encryption - EKM Challenge Changed
EE 50 Encryption - Initiator Identifier Changed
EE 51 Encryption - Initiator Response Changed
2A 11 Encryption - Data Encryption Parameters Changed by Another I_T Nexus
2A 12 Encryption - Data Encryption Parameters Changed by Vendor Specific Event
Sense Key 7 (Data Protect)
EF 10 Encryption - Key Required
EF 11 Encryption - Key Generation
EF 13 Encryption - Key Translate
EF 1A Encryption - Key Optional
EF C0 Encryption - No Operation
26 10 Encryption - Data Decryption Key Fail Limit
2A 13 Encryption - Data Encryption Key Instance Counter Changed
74 00 Security Error
74 01 Encryption - Unable to Decrypt Data
74 02 Encryption - Unencrypted Data Encountered While Decrypting
74 03 Encryption - Incorrect Data Encryption Key
74 04 Encryption - Cryptographic Integrity Validation Failed
74 05 Encryption - Error Decrypting Data
The descriptions below serve only as an overview of sense reporting in the tape
drive. This tape drive conforms to all sense field reporting as specified in the SCSI
standards.
1. The Error Code field (Byte 0) is set to 70h to indicate a current error, that is
one associated with the most recently received command. It is set to 71h to
indicate a deferred error which is not associated with the current command.
2. The segment number (Byte 1) is zero since the Copy, Compare, and Copy and
Verify commands are not supported.
C-8 Dell PowerVault TL1000 Tape Autoloader User's Guide