Dell PowerVault TL1000 - Manual (Page 45)

9. Secure the rear of the library to the rack with a round-head screw 10 on
each rear bracket (Figure 3-7). Tighten the other rear bracket screws to secure
the library to the rack.
10. Run the SAS cable, power cable, and Ethernet cable through the
hook-and-loop fastener strap 12 . Leave enough slack to reach the
corresponding connectors, then tighten the strap (Figure 3-8).
Note: For information about converting and relocating the library, see
Chapter 8, “Removal and replacement procedures,” on page 8-1.
Removing the accessor locking screw
Important: The accessor locking screw prevents the library accessor from moving
during shipment and must be removed before the library is powered
ON.
Remove the accessor locking screw, located on the rear panel of the library ( 1 in
Figure 3-9 on page 3-8).
a29z0022
10 10
Figure 3-7. Securing the rear of the library in the rack
a29z0023
12
Figure 3-8. The cables at the rear of the library
Chapter 3. Installation and configuration 3-7