Dell C7765DN MFP Color Laser Printer - Manual (Page 329)

Common Service Settings
329
Maintenance
You can initialize or delete data from the hard disk of the machine.
Initialize Hard Disk
Initializes the hard disk.
Note • The secure print documents and logs are not erased.
Data deleted by initialization includes supplementary fonts and ESC/P forms.
Delete All Data
This feature is designed to prevent the leakage of confidential information of a customer
when the machine is returned to Dell. By executing [Start], all data registered on the
machine is deleted.
Note • It takes several minutes to several hours to delete all data. (The time taken depends on the machine
configuration or the hard disk capacity.)
Software Options
This feature is for service representative use. For more information, contact Customer
Support at dell.com/contactdell.
Power on Self Test
Set whether or not to perform self test when the machine is turned on and started up.
If any abnormal condition such as intentional program modification is found during the
program diagnosis, the machine stops starting up and records the information in the audit
log.
Note • The information may not be recorded in the audit log depending on the status of program malfunction.
• If the machine does not start, contact Customer Support at dell.com/contactdell.
Check Smart Card Details
When you select [Check Smart Card Details] and touch your smart card to the smart card
reader, the information of the smart card appears on the touch screen.
Note • You can register the authentication information using Dell Printer Configuration Web Tool.
Finisher Adjustment
This feature is displayed only when the Finisher-B1 (optional), the Booklet Maker Unit for
Finisher-B1 (optional), or the Hole Punch Unit (optional) is installed.
Hole Punch Tool
Specify either 2/4 Hole Punch or 2/3 Hole Punch (US Specification).
Adjust Punch Position/Booklet Fold Position
Set the punch position and booklet fold position for paper smaller than B4 or larger than or
equal to B4.
Adjust Image Transfer
You can specify the transfer output value for each paper type. This is useful when the toner
image does not transfer to the paper properly.