LaMotte SMART Spectro Spectrophotometer - Manual (Page 26)

26 SMART Spectro Operator’s Manual 2.11
SEQUENCES OF TESTS
SEQUENCE 1, SEQUENCE 2, and SEQUENCE 3 are alterable sequences.
They may be edited using the EDIT function mode. Any of the LaMotte pre-
programmed tests or User Tests may be placed in these sequences in whatever
testing order that is preferred. Some examples of typical sequences are given
below.
SEQUENCE 1 SEQUENCE 2 SEQUENCE 3
* 60 Molybdenum LR * 1 Aluminum * 3 Ammonia-N L F
79 Phosphate 35 Cyanide 32 Copper DDC
9 Bromine LR 41 Fluoride 64 Nitrate-N LR
76 pH TB 53 Iron Phen 67 Nitrite-N LR
15 Chlorine 55 Manganese L 74 pH CPR
86 Silica HI 64 Nitrate N LR 78 Phosphate L
45 Hydrazine 26 COD Low 85 Silica Lo
32 Copper DDC 77 Phenols END OF LIST
51 Iron Bipyr 78 Phosphate L
END OF LIST 90 Sulfi de LR
END OF LIST
NOTE: Sequences always end with END OF LIST to indicate that there are no
more tests in the sequence.
These alterable sequences allow a series of tests to be setup that are run
frequently. The order of the individual tests in the sequence is determined by the
user. After running a test, press EXIT to escape back to the Sequence menu.
Move the down to the next test listed and press * ENTER. Continue this
pattern until the entire sequence has been completed.
ALL TESTS is a fi xed sequence containing the LaMotte pre-programmed tests
and User Tests.
Modifi cation of the alterable sequence is accomplished through the
EDIT
function. This function is explained in detail in the section titled EDIT.
It should be noted that if a %T/ABS test is to be included in a sequence, the
%T/ABS test must fi rst be setup as a User Test (but no actual calibration needs
to be performed, only select a name and wavelength).
Pressing the
EXIT button while in a sequence menu will escape back to the
PROGRAMMED TESTS menu.
Pressing the
OFF button at any time will turn the SMART Spectro off.