Metrohm 751 GPD Titrino - Manual (Page 83)

2.10. Data output
751 GPD Titrino
80
2.10 Data output
2.10.1 Reports for the output at the end of a determination
With , the report sequence at the end of the
determination is defined.
The entries are specific to the method and are stored in
the method memory.
report:
Definition of report blocks to be printed automatically at
the end of the determination.
The display texts of the Titrino are shown to the left.
The values are the default values.
>report
report COM1:
report COM1:full;curve
Report sequence for COM1 (input range depends on
the mode:
DET: full, short, mplist, curve, derive, comb, scalc full,
scalc srt, param, calc, calib, ff
MET, SET, MEAS:
full, short, mplist, curve, scalc full, scalc srt,
param, calc, calib, ff
STAT, DOC:
full short, mplist, curve, meas crv, temp crv,
scalc full, scalc srt, param, calc, calib, ff
DOS: full, short, mplist, curve, meas crv, temp crv,
scalc full, scalc srt, param, calc, ff
CAL: full, short, scalc full, scalc srt, param, calc, calib,
ff
KFT: full, short, mplist, curve, scalc full, scalc srt,
param, calc, ff
TIP: full, short, scalc full, scalc srt, param, calc, ff
Select a block. If you require more than one report
block, set a ";" as a delimiter between the blocks.
Identical for COM2.
Meaning of the report blocks:
full Full result report with raw results, calculations and statistics.
short Short result report with calculations and statistics.
mplist Measuring point list.
curve Titration curve (with DET and MET) or volume vs. time (with SET, KFT, STAT,
DOS, and DOC) or measured value vs. time (with MEAS)
derive 1st derivative of the titration curve (with DET)
comb Combined titration curve and 1st derivative (with DET)
meas crv Measured value vs. time (with STAT, DOS and DOC; monitoring of meas
active).
temp crv Temperature vs. time (with STAT, DOS and DOC; monitoring of temperature
active).
DEF
(
2
def
>formula
>silo calculations
>common variables
>report
>mean
>temporary variables