Metrohm 751 GPD Titrino - Manual (Page 163)

3.2. Remote control commands
751 GPD Titrino
160
3.2.2. 3.2.2.85. 85. Me MemoryCard.Rel Reload $G
Me MemoryCard.Rel Reload.NName up to 10 ASCII characters
Reload a backup from the memory card into the internal memory. The action is
carried out if "$G" is transmitted to the corresponding node.
Do not use blank characters before and after name!
3.2.2. 3.2.2.86. 86. Me MemoryCard.FFormat $G
Me MemoryCard.CCardLabel.NName up to 8 ASCII characters
Format the memory card. The action is carried out if "$G" is transmitted to the
corresponding node.
Do not use blank characters before and after name!
3.2.2. 3.2.2.87. 87. Me MemoryCard.Fr FreeMem read only
Free memory on the card. $Q sends number of free bytes, e.g. "4928".
3.2.2. 3.2.2.88. 88. Me MemoryCard.Bat BatteryChange $G
Me MemoryCard.Bat BatteryChange.DDate YYYY-MM-DD
Date for changing battery. The date will be set with "$G".
3.2.2. 3.2.2.89. 89. Me MemoryCard.LList.C .Card.1.N .1.Name read only
Me MemoryCard.LList.C .Card.1.B .1.Bytes read only
for each directory
List of all directories on the memory card with the following information:
.Name:
Name of the directory
.Bytes: Number of bytes used by the directory
3.2.2. 3.2.2.90. 90. Me MemoryCard.L .List.AActDir.1.NName read only
Me MemoryCard.LList.AActDir.1.M Mode read only
M MeemoryCard.LList.AActDir.1.QQuantity read only
Me MemoryCard.LList.AActDir.1.DDosUnit read only
Me MemoryCard.LList.AActDir.1.BBytes read only
Me MemoryCard.LList.AActDir.1.CChecksum read only
for each method
List of all methods of the current card directory with the following information:
.Name:
Name of the method
.Mode: Mode
.Quantity: Measured quantity
.DosUnit: Buret of the method
.Bytes:
Number of bytes used by the method
.Checksum: Checksum of the method, see 3.2.2.133.
3.2.2. 3.2.2.91. 91. CConfig.M .Monitoring.V .Validation.S .Status ON, OFF OFF
CConfig.M .Monitoring.V .Validation.I.Interval 1...365 365...9999
CConfig.M .Monitoring.V .Validation.C .Counter 00...9999
CConfig.M .Monitoring.V .Validation.Cl .ClearCount $G