Metrohm 751 GPD Titrino - Manual (Page 212)

5.1 Setting up and connecting the instruments
751 GPD Titrino
209
5.1.4 Connection of a balance
The following balances can be connected to the RS232 output of the
Titrino:
Balance Cable
Sartorius MP8, MC1 6.2134.060
Mettler AB, AG (LC-RS25) in the scope of delivery of the balance
Mettler AM, PM 6.2146.020 + 6.2125.010
additionally from Mettler:
ME 47473 Adapter and ME 42500 hand switch or ME
46278 foot switch
Mettler interface 016 Cable in scope of delivery of interface 016: red lead
to pin 3, white lead to pin 7 of the 25-pin connector
+ 6.2125.010 25-pole/9-pole adapter
Mettler interface 011 or 012 6.2125.020 + 6.2125.010
Mettler AT 6.2146.020 + 6.2125.010
Mettler PG 6.2134.110
AND Models ER-60, 120, 180, 182
Models FR-200, 300
Models FX-200, 300, 320
with RS232 interface (OP-03)
6.2125.020 + 6.2125.010
Precisa, balances with RS232C-
interface 6.2125.080 + 6.2125.010
The balance type must be preselected at the GP Titrino with the
key.
The weight is transferred as a number with up to 6 digits, sign and
decimal point. Units and control characters sent by the balance are
not transmitted.
With the aid of a special input unit supplied by the balance manu-
facturer, in addition to the weight identifications and methods can be
inputted from the balance. For this, the address of the identifications
and method, resp. must be preselected on the input unit.
Balance Method Id1 Id2 Id3
Sartorius METH or 27 ID.1 or 26 ID.2 or 24 C-20 or 23
Mettler (AT) D (Mthd) C (ID # 1) B (ID # 2) A (c20)
If balance and printer are connected at the same Titrino COM you
need the 6.2125.010 and 6.2125.030 Adapters.
If the balance works only with 7 bit and the printer with 8 bit and if
they are at the same Titrino COM, the balance has to bet to "space
parity" and Titrino/printer to 8 bit, "no parity".