Metrohm viva 1.1 - Manual (Page 954)

7.11 Stepping Motor Controller
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
942 ￭￭￭￭￭￭￭￭
viva 1.1
Entry 50 characters
Default value Device type number_#
Device type
Shows the device type.
Wrapper version
Shows the version of the AdsWrapper.dll.
Firmware version
Shows the PLC firmware version on the bus controller. Consists of the bus
controller firmware and the version of the bus controller program.
AdsDll version
Shows the version of the AdsDll.dll.
Device serial number
Shows the serial number of the device.
Set to work
Shows the date on which the device was automatically added to the
device table.
Remarks
Remarks about the device.
Entry 1,000 characters
Default value empty
7.11.3 Properties - Settings
Tab: Configuration ▶ Devices ▶ [Edit] ▶ Properties... ▶ Properties - 'Device type' -
'Device name' ▶ Settings
The IP address of the controller and the controller ID are entered on the
Settings tab.
NOTE
These parameters can only be edited when a device is first added.
IP address
IP address under which the controller is to be actuated, normally:
￭ 172.16.17.3 for IO controllers
￭ 172.16.17.4 for Stepping Motor Controller