Metrohm viva 1.1 - Manual (Page 508)

5.5 Method run subwindow
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
496 ￭￭￭￭￭￭￭￭
viva 1.1
Parameters
The parameters for the SCAN command are configured in the following
dialog window:
￭ SCAN - Properties
Command variables
The following command variables are generated by the SCAN command
in the method run and can be used in formulas under the designation
'Command name.Variable identification':
Identification Description
BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command
has never been started
FIN Command status:
1 = Command has ended at least once
0 = Command has not yet ended
not valid (variable not available) = Command
has not yet been started
TOU Timeout status: 1 = Max. timeout expired; 0 =
Max. timeout not expired
5.5.2.6.3.2 SCAN - Properties
Dialog window: Method ▶ SCAN ▶ Properties... ▶ SCAN - 'Command name'
Command name
Name of the command.
Entry 25 characters
Device
Device name
Selection of a device from those available in the device table. Only devices
with which the command can be executed are available.
Selection 'Device name' | not defined
Default value not defined
not defined
In this case, the device name must be assigned by the user at the start
of the method.