Metrohm viva 1.1 - Manual (Page 423)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
5 Method
viva 1.1
￭￭￭￭￭￭￭￭ 411
Command variables
The following command variables are generated by the command CALL
in the method run and can be used in formulas under the designation
'Command name.Variable identification':
Identification Description
BSY Command status:
1 = BUSY, HOLD or ERROR
0 = READY
invalid (variable not available) = Command has
never been started
FIN Command status:
1 = Command has ended at least once
0 = Command has not yet ended
invalid (variable not available) = Command has
never been started
5.5.2.2.2.2 CALL - Properties
Dialog window: Method ▶ CALL ▶ Properties... ▶ CALL - Call #
Command name
Name of the command.
Entry 25 characters
Call table
All of the defined calls that are listed in the table are executed simultane-
ously. The table cannot be edited directly.
NOTE
The CALL command waits until all of the called tracks have been com-
pleted or have reported in. If there is to be no waiting for the comple-
tion of a track, then the Return immediately check box must be acti-
vated in the respective track command (see Chapter 5.5.2.9.1, page
576).
[New]
Opens the Call - New dialog window for entering a new call (see Chap-
ter 5.5.2.2.2.3, page 412).