Metrohm viva 1.1 - Manual (Page 920)

7.10 IO controller
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
908 ￭￭￭￭￭￭￭￭
viva 1.1
7.10.3 Properties - Settings
Tab: Configuration ▶ Devices ▶ [Edit] ▶ Properties... ▶ Properties - 'Device type' -
'Device name' ▶ Settings
The IP address of the controller and the controller ID are entered on the
Settings tab.
NOTE
These parameters can only be edited when a device is first added.
IP address
IP address under which the controller is to be actuated, normally:
￭ 172.16.17.3 for IO controllers
￭ 172.16.17.4 for Stepping Motor Controller
Entry xxx.xxx.xxx.xxx
Controller ID
Number of the controller in the system. This number must be unique
across all controllers in the system (IO controllers and Stepping Motor
Controllers).
Entry Digit
Is used as the first figure (x) of the port name, as in
DigIN_x_y_z.
7.10.4 Properties - Digital inputs
All recognized inputs are automatically listed in a table on the Digital
inputs tab. The port designation can be changed for each digital input.
Port
Shows the internal designation of the port.
Port description
Shows the port designation.
Port specification
Shows the port specification.
Type
Shows the port type.