Bird Technologies SH-36S-RM-Manual - Manual (Page 99)

Maintenance
83
4. Connect the unit to the PC via USB cable.
5. Turn on the SignalHawk.
6. Select “Install the software automatically...” if the “Found New
Hardware Wizard” is presented.
Note:
Both program wizards will run co-currently. See
“Installing the SignalHawk Program” on page 9 for the PC
SignalHawk.
7. Click “Next.”
Figure 63 DSP List
8. Select the unit from the list presented.
9. Select the images that need updating.
10. Click “Next” repeatedly until the update is completed.
Figure 64 Image Selection
11. Cycle power when prompted by the program wizard.