beautypg.com

External trigger, Single, External - low level / high level – Bird Technologies SH-36S-RM-Manual User Manual

Page 55: Gate delay

background image

Settings

39

Single

Performs a single sweep. Before a single sweep is triggered, the Sig-
nalHawk will display the previous sweep. To begin a sweep, press the
Manual Trigger soft key. After the sweep finishes, it will display the
results and stop sweeping.

Trigger -

Sets the type of trigger that initiates a sweep. There are four

types of trigger to choose from:

z

Internal Continuous - Sweeps continuously and is con-
trolled by the SignalHawk.

z

Internal Single - Sweeps once when triggered. Controlled by
the SignalHawk through the Arm Trigger soft key.

z

External Continuous - See “External Trigger” below.

z

External Single - See “External Trigger” below.

Note:

Useful for signals that are time varying. Ones that

change slow enough to trigger manually as well as carrier/inter-
ference ratios. See “Carrier-to-Interference Ratio” on page 63.

Arm Trigger -

Manually initiates a sweep.

External Trigger

External - Low Level / High Level /
Rise Edge / Fall Edge / Either Edge

z

Low Level - Triggers if input = 0 ± 0.5 V (TTL “Low”).

z

High Level - Triggers if input = 4.2 ± 0.8 V (TTL “High”).

z

Rise Edge - Triggers if the input goes from “Low” to “High”.

z

Fall Edge - Triggers if the input goes from “High” to “Low”.

z

Either Edge - Triggers if the input goes from either “High” to
“Low” OR “Low” to “High”.

Gate Delay

Length of wait after the trigger signal and before beginning a sweep.
The range is 100 µs to 1 s.

This manual is related to the following products: