Bird Technologies SH-36S-RM-Manual - Manual (Page 31)

Rack Mount SignalHawk Set-Up
15
9. Turn power on.
10. Select “Install the software automatically…” in the Found New
Hardware Wizard window.
Note:
This procedure is performed when connecting either
a PC or Rack-Mount SignalHawk for the first time. Driver
installation is required for every distinct SH-36S-PC or SH-
36S-RM connected to the computer.
Figure 9 Found New Hardware Wizard
11. Click “Next”.
12. Follow the instructions that are presented.
13. Click “Finish” in the Completing the Found New Hardware Wizard
window.
Figure 10 Completing the Found New Hardware Wizard
14. Launch the SignalHawk program.
15. Select the SignalHawk unit from the Select DSP Device list.