Chapter 2 pc signalhawk set-up, Installing the signalhawk program – Bird Technologies SH-36S-RM-Manual User Manual
Page 25

9
Chapter 2
PC SignalHawk Set-Up
Installing the SignalHawk Program
Note:
Install the PC software before connecting the PC
SignalHawk for the first time.
1. Insert installation CD.
2. Select Install Software when prompted.
Note:
Set-up will inspect the computer for any missing
operating system prerequisites. If all are present, skip to step 6.
3. Select “Next” and the install utility begins the Prerequisites
Installation process.
4. Review the End-User License Agreement, check “I accept the
terms of the License Agreement” and select “Install.”
Note:
The install Utility will install the prerequisites. This
may take several minutes
Note:
When completed, check with Microsoft
®
support cen-
ter for any security updates. Typically, if “Automatic Updates”
are configured on the host PC, these will be automatically
flagged and selected for download and installation.
Note:
The installation utility will launch after the OS pre-
requisites are installed.
5. Do one of the following:
z
Accept the default installation location.
z
Select a different folder.
6. Select “Next” and the installer will complete.
7. Select “Finish” to launch the SignalHawk program.
8. Connect PC SignalHawk to a PC using the supplied USB cable.
Note:
The “USB Host Power” LED will illuminate when the
host port is active and has power. It is not an indication of proper
USB connectivity to the host. Refer to software installation
instructions for how to address the PC SignalHawk from the host.
9. Turn power on.
10. Select “Install the software automatically…” in the Found New
Hardware Wizard window.