Bird Technologies SH-36S-RM-Manual - Manual (Page 61)

Settings
45
Markers Detect
Toggles the functionality of the submenu between finding peaks or
finding valleys.
Threshold
The threshold offset, displayed on the first line, is used to calculate the
threshold level, displayed on the second line, above the noise floor.
Note:
The low level peaks below the threshold level are fil-
tered out. Only peaks above or at the threshold level are detected.
Marker to Max Peak or Marker to Min Valley
Sets the marker to the either the maximum peak or minimum valley
depending on the functionality chosen in Markers Detect. See “Mark-
ers Detect” on page 45.
Marker to Next Peak Left or Marker to Next Valley Left
Cycles the active marker to the left through the points on the trace
either from highest peaks or lowest valleys (see “Markers Detect” on
page 45) progressing to the left.
Marker to Next Peak Right or Marker to Next Valley Right
Cycles the active marker to the right through the points on the trace
either from highest peaks or lowest valleys (see “Markers Detect” on
page 45) progressing to the right.
All Markers to Max Peaks or All Markers to Min Valleys
Sets all the markers to either the maximum peaks or minimum val-
leys depending on the functionality chosen in Markers Detect. See
“Markers Detect” on page 45.
All Markers Off
Turns off all markers on the trace.
Marker Delta
Turns On/Off and displays the delta of the one to five markers.
Marker Display
Marker Type
Sets the current marker to either be displayed as a line or floating
numbered icon.
All Markers Type to Icon
Sets all markers to be displayed as floating numbered icons.
All Markers Type to Line
Sets all markers to be displayed as numbered lines.
Marker Display
Turns On/Off and sets the location of the delta display into one of the
four corners of the screen.