beautypg.com

Power supply - rack-mount signalhawk, Ac power connector, Dc supply – Bird Technologies SH-36S-RM-Manual User Manual

Page 22: Ac power connector dc supply

background image

Bird Technologies

6

Power Supply - Rack-Mount SignalHawk

AC Power Connector

The AC Power connector provides operating power for the Rack-Mount

SignalHawk. The AC power supply cord is also the line disconnect

device for this product. Use the supplied AC power cord or an approved

power cord to connect to the Rack-Mount SignalHawk, such as domestic

type SVT, 300 VAC, 18 AWG, 10 A, 3 conductor (including ground) or

international type H05VV-F, 300 VAC, 1.00 mm, 10 A, 3 conductor

(including ground).

Note:

The Rack-Mount SignalHawk is shipped from the

factory configured for 110VAC operation, 2-pole fuse (fused line

and neutral). If the Rack-Mount SignalHawk will be installed

with 220VAC supply, follow these instructions:

1. Remove the fuse drawer from the power entry module on the rear

of the unit.

2. Remove fuses from drawer & set aside.

Note:

There are two different fuse drawers supplied with

the Rack-Mount SignalHawk. One is a 2-pole fuse tray (fuse on

both lines) the other is a single fuse tray (line fuse, shorting bar

on neutral). Check with local regulations to determine whether

single or dual pole fuse protection is required.

3. Install one or both fuses into the appropriate fuse drawer:

z

110VAC operation: 5x20mm SLO BLO 1.25A

z

220VAC operation: 5x20mm SLO BLO 0.63A

4. Replace fuse drawer into the power entry module
5. Insert AC power cord into the IEC receptacle on the power entry

module.

DC Supply

The Rack-Mount SignalHawk can also be powered by a direct DC volt-

age wired into the terminal lugs on the rear of the unit. This is useful

if the installation site has DC power readily available or it can be con-

nected in addition to the AC power if the DC source is part of a battery

back-up system. There are two separate DC power inputs on the ter-

minal connector. The combination of the two allows a wide range of

DC voltage sources. Refer to the specifications page for voltage range

and current requirements.

Note:

Ensure proper polarity is observed on the DC supply

and input voltage is connected to the correct pair of terminal lugs.

This manual is related to the following products: