AJA FS1-X Manual - Manual (Page 63)

FS1-X v1.1 www.aja.com 63
15.1 MADI BNC Out
This parameter controls the number of MADI channels sent to the MADI BNC output
connector. When the FS1-X receives 56 channels and outputs 64 channels, active silent
channels 57 to 64 are added. When the FS1-X receives 64 channels and outputs 56
channels, channels 57 to 64 are dropped.
15.1 MADI Fiber Out
This parameter controls the number of MADI channels sent to the MADI Fiber output
connector. When the FS1-X receives 56 channels and outputs 64 channels, active silent
channels 57 to 64 are added. When the FS1-X receives 64 channels and outputs 56
channels, channels 57 to 64 are dropped.
VIDEO PROC Menu Group
The following descriptions explain the Video Proc Menu Groups. The Video Proc menu
displays are formatted as follows
The currently selected Input video source and output video format for Video Processor 1
is reported on the bottom line of each menu.
Video Input and
Output
These parameters perform input video source selection for the selected Video Processor
(1 or 2). Multiple input sources are available at the connectors on the FS1-X rear panel,
but the active input source routed to the selected Video Processor is the one you select
here.
1.1 Video 1 Input
Source Memory Changing the Video Input selection automatically selects new values for Proc Amp
parameters and Color Corrector (RGB) parameters. Each video source remembers its own
Proc Amp and Color Corrector settings. This is referred to as Source Memory.
64ch (default)
56ch Sixty four audio channels selected for MADI BNC output.
Fifty six audio channels selected for MADI BNC output.
64ch (default)
56ch Sixty four audio channels selected for MADI Fiber output.
Fifty six audio channels selected for MADI Fiber output.
Display Description
MENU # TITLE
PARAMETER VALUE
INPUT FORMAT
Menu number and title.
Currently selected parameter value for this menu.
Video Processor 1 Input Output Format
SDI1 (default)
SDI2
SDI DualLink
Fiber1
Fiber2
Fiber DualLink
HDMI
Analog Select SDI1 as the input source.
Select SDI2 as the input source.
Select SDI DualLink, linking both SDI inputs as the input source.
Select Fiber1 as the input source.
Select Fiber2 as the input source.
Select Fiber DualLink, linking both Fiber inputs as the input sources.
Select the HDMI input as the input source.
Select Analog as the input source. Component or Composite analog
video is set with “1 Analog In Format” on page 58 .