Rockwell Automation MinPak Plus DC Drives Kits - Manual (Page 7)

6
Table 2.C - SPECIFICATIONS
AĆC Line Input Voltage
115/230 VAC (nominal)
singleĆphase only
Line Voltage Variation
"10% of nominal
AĆC Line Frequency
Single Phase, 50/60 Hz
(Jumper selectable)➀
Line Frequency Range
48Ć62 Hz
Output Voltages
(armature andfield)
See Table 2.D
ControllerĆDrive HP Range
1/4Ć3/4 hp (with 115 VAC input)
1/2Ć5 hp (with 230 VAC input)
Direction Control
Forward/Reverse
Maximum SpeedAdjustment
50Ć100% of base motor speed
(user adjustable)
Minimum SpeedAdjustment
0Ć50% of base motor speed
(user adjustable)
Operator SpeedAdjustment
Infinitely adjustable with
optional control pot
(0Ć100% of base speed)
Operator Torque Adjustment
Infinitely adjustable at
optional control pot
(10Ć150% of rated load)
Controllable SpeedRange
20:1
Current Limit
Factory shipped: 150% of full load
User adjustable: 10Ć150% of full load
(User separately adjustable
positive and negative)
Regulation
(with 95% loadchange)
3Ć5% with voltage feedback
1.0% with specified tachometer feedback
0.5% with specified tachometer feedback
Minimum Loadfor Stable Operation
5%
Armature Circuit OverloadCapacity
150% of armature current rating
for 1 minute (max.)
Efficiency
(rated speed/rated load)
Controller only: 97%
Complete drive including
motor: 85% (typical)➁
Displacement Power Factor
68% (typical)➁
Circuit Breaker Interrupting Capacity
1000 amps to 1 hp
5000 amps 1Ć1/2Ć5 hp
Transient Protection
MOV, Output RC Circuit, and
Thyristor RC Circuits (4)
Controller Service Factor
1.0
Duty
Continuous
Storage Ambient Temperature
0 ° Ć55 ° C (32 ° -131 ° F)
Operational Ambient Temperature
Chassis: 0 ° -55 ° C (32 ° -131 ° F)
Cabinet: 0 ° -40 ° C (32 ° -104 ° F)
Relative Humidity
(storage andoperational)
5-95%
(without condensation)
Operational Altitude
To 3300 ft (1000 m) above
sea level without derating
Controller Enclosure Rating
NEMA Type 4 and 12➂
(watertight, as defined)
Controller Weight (approx.)
3/4, 1Ć1/2, 3 hp = 14.4 lb (6.5 kg)
5 hp = 15.1 lb (6.9 kg)
Shipping Box Weight (approx.)
3/4, 1Ć1/2, 3 hp = 16.4 lb (7.4 kg)
5 hp=17.1 Ib (7.8kg)
(Figures include all optional Kits)
Controller Dimensions (LWD)
14Ć15/16 x 9Ć7/8 x 7Ć3/8 inch
(370 x 247 x 184 mm)
5%
Acceleration/Deceleration Rates
0.5Ć30 sec. linear time
(userĆadjusted separately)
➀ See Paragraph 3.9.
➁ Typical percent shown. Exact figure dependent on motor
base speed and frame size.
➂
Assumes proper installation procedures.