Rockwell Automation 2080-LC10-12DWD Micro810 Programmable Controllers User Manual - Manual (Page 99)

Rockwell Automation Publication 2080-UM001D-EN-E - September 2012 91
Quickstarts Appendix C
8. Press the push button connected to I03. The elapsed time ET starts to
elapse and the pilot light turns on.
When the current elapsed time ET = programmed time PT, the output
O02 is de-energized, and the pilot light turns off.
Configure TOF
1. Power up the Micro810 controller.
The Micro810 splash screen briefly appears after power up.
2. The status display shows PROG mode, the day and time, and the I/O
status. Press the ESC and OK buttons at the same time to navigate to the
Main Menu.
3. Press the DOWN arrow button once to select SR Function. Press the OK
button. The function block for controlling Output 0 is displayed.
4. Press the DOWN arrow button once to select Output 3.
a. Press the RIGHT arrow button once to select the DOY instruction
parameter field.
5. Press the UP arrow button once to go to TOF instruction.
TOF – Sample Parameter Configuration
Parameter field Config value
Q Q03
IN I02
Time Resolution SS:MS
PT 15:000