Rockwell Automation 2080-LC10-12DWD Micro810 Programmable Controllers User Manual - Manual (Page 50)

40 Rockwell Automation Publication 2080-UM001D-EN-E - September 2012
Chapter 7 Controller Security
controller in the Micro800 project, and then downloading to controller2. Finally,
controller2 will be locked.
1. On the Device Toolbox, open Discover and click Browse Connections.
2. Select target controller1.
3. When requested, enter the controller password for controller1.
4. Build and save the project.
5. Click Disconnect.
6. Power down controller1.
7. Swap controller1 hardware with controller2 hardware.
8. Power up controller2.
9. Click Connect.
10. Select target controller2.
11. Click Download.
12. Lock controller2. See Configure Controller Password on page 279 .
Back Up a Password-Protected Controller
In this workflow, user application will be backed up from a Micro800 controller
that is locked to a memory plug-in device.
1. On the Device Toolbox, open Discover. Click Browse Connections.
2. Select the target controller.
3. When requested, enter the controller password.
4. Back up controller contents from the memory module.
Configure Controller
Password To set, change, and clear controller password, see the quickstart instructions
Configure Controller Password on page 279 .
Recover from a Lost
Password If the controller is secured with a password and the password has been lost, then it
is impossible to access the controller using the Connected Components
Workbench software.
To recover, the controller must be set to Program Mode using the keyswitch for
Micro830 and Micro850 controllers, or the 2080-LCD for Micro810 controllers.
Then, ControlFlash can be used to update the controller firmware, which also
clears the controller memory.