Rockwell Automation 2080-LC10-12DWD Micro810 Programmable Controllers User Manual - Manual (Page 68)

60 Rockwell Automation Publication 2080-UM001D-EN-E - September 2012
Appendix C Quickstarts
4. Enter the OLD password you have previously set using the arrow buttons.
– left and right arrows move to the 8-digit entry field
– left and right arrows select digit in password
– up and down arrows set a value between 0 and 9.
5. Enter the New Password using the arrow buttons.
6. Press OK.
Delete Password
You need to set the password as 00000000 to delete the password that has been
previously set. To do this, follow the next instructions:
1. Press Esc and OK to call up the System menu.
2. Select the menu item SECURITY.
3. Press the OK button and select Change PWD.
Change Password option is available only if a password has been
previously set.
4. Enter the OLD password you have previously set using the arrow buttons.
– left and right arrows move to the 8-digit entry field
– left and right arrows select digit in password
TIP Deleting the password effectively unlocks the LCD. On the next controller
power cycle, a password will not be required to access system functions
on the LCD.