Rockwell Automation 2080-LC10-12DWD Micro810 Programmable Controllers User Manual - Manual (Page 70)

62 Rockwell Automation Publication 2080-UM001D-EN-E - September 2012
Appendix C Quickstarts
Configure Controller
Password Set, change, and clear the password on a target controller through the Connected
Components Workbench software.
Set Controller Password
In the following instructions, the Connected Components Workbench software
is connected to the Micro800 controller.
1. On the Connected Components Workbench software, open the project
for the target controller.
2. Click Connect to connect to the target controller.
3. On the Device Details toolbar, roll over the Secure button. The tooltip
message “Set, Change. or Clear Micro800 Controller Password
Protection” is displayed.
IMPORTANT The following instructions are supported on Connected Components
Workbench revision 2 and Micro800 controllers with firmware revision 2.
For more information about this feature, see Controller Security on
page 235 .