Rockwell Automation 2080-LC10-12DWD Micro810 Programmable Controllers User Manual - Manual (Page 65)

Rockwell Automation Publication 2080-UM001D-EN-E - September 2012 57
Appendix
C
Quickstarts
This appendix covers some common tasks for the Micro810 controller. It
includes the following quickstart instructions:
Configure LCD Password The Micro810 function relay settings which are accessible through the LCD can
be password protected. The password consists of a value between 00000001 and
99999999.
Password protection blocks access to the System menu and thus offers protection
against the following:
• modification of function relay parameters
• changing between operating modes Run or Stop.
• settings of the real-time clock
• communication with individual device
• modification of system parameters
– set new password
– menu language selection
– input filter
– AI Calibration
– Power Up Behavior
– Memory Module
Topic Page
Configure LCD Password 57
Configure Controller Password 62
Use the Micro810 Smart Relay Functionality 66
Flash Update the Micro800 Firmware 94
Establish Communication Between RSLinx and a Micro810 12-point
controller through USB 99
Forcing I/O 101
TIP The number combination 00000000 is used to delete the password.