Rockwell Automation 1771-QC , D17716.5.25 SER/B SERVO POS - Manual (Page 54)

Installing the Assembly
Chapter 6
6Ć4
This publication shows and describes switches as being on or off. Printed
on the actual switch assemblies are the words ON and OFF or the word
OPEN. OPEN corresponds to OFF.
Use a blunt-pointed instrument such as a ball-point pen to set these
switches. Never use a pencil; graphite could jam the switch.
Figure 6.2 shows details of a jumper connecting two pins. Each jumper
connects two of a set of three pins. To change a jumper setting, follow
these steps:
1. Pull the jumper straight up.
2. Position the jumper over the pins you want to connect.
3. Push the jumper straight down.
If you position the jumper correctly, it slides down over the pins easily.
Figure 6.2
Jumper in the Left Position
12014