Rockwell Automation 1336-GM6 Enhanced DeviceNet Communications Module User Manual

Page 25

Installation

2-5

You must now edit the adapter’s node address, and you may want to
edit some of its other parameters. Refer to the following table for
information:

Removing the 1203-GU6 Communications Module

To remove the 1203-GU6 communications module, you need to:

1. If necessary, remove any serial connections from the DF-1 serial

port.

2. Remove the SCANport cable from the SCANport product and

then from the module. This will power down the module if the
SCANport product is powered.

3. Unscrew (using a 1/8" flathead screwdriver) and then unplug the

5-pin or 10-pin connector from the module.

4. Insert a flathead screwdriver into the module’s DIN rail tab

release and gently push the handle toward the module to release
the connection tab. Then pull the module up and off the DIN rail.

Figure 2.5

Removing the Module from the DIN Rail

If using:

Then refer to:

1203-GU6 module’s serial connection

1203-GU6 module’s DeviceNet connection

This manual is related to the following products: