Rockwell Automation 1336-GM6 Enhanced DeviceNet Communications Module - Manual (Page 24)

2-4 Installation
4. Plug the connector into the module.
Figure 2.3 Inserting a 5-pin or 10-pin Phoenix Connector
5. Use a 1/8" flathead screwdriver to screw the connector firmly into
place.
6. Connect the SCANport cable to the communications adapter and
then to the SCANport product.
Important: Because the adapter’s power comes from the SCANport
product, the adapter will not function if the SCANport product is not
powered.
Figure 2.4 Inserting the SCANport Cable
7. Reapply power to the network.
8. If necessary, apply power to the connected SCANport product.
Your 1203-GU6 module is now installed. The SCANport LED is
green. The network and module LEDs are blinking green. If your
module’s LEDs are different, refer to Chapter 8, Troubleshooting, for
more information.