Rockwell Automation 1336-GM6 Enhanced DeviceNet Communications Module - Manual (Page 137)

Appendix
E
N-File Addresses
Appendix Objectives Appendix E provides information on the N-File addresses used when
accessing the PCCC object or the DF-1 serial port. When using
messages, you can use the N-file addresses to locate information
about the adapter or SCANport product.
N-File Addresses The 1203-GU-6 and 1336-GM6 support the N-file addresses shown
below:
Address N-File Addresses
N10:0 Number of SCANport product parameters
N10:1 – 999 SCANport product parameters 1 – 999 (value only)
N11:0 – 999 SCANport product parameters 1000 – 1999 (value only)
N12:0 – 999 SCANport product parameters 2000 – 2999 (value only)
N13:0 Number of SCANport adapter parameters
N13:1 – 999 SCANport adapter parameters 1 – 999 (value only)
N30:1 – 999 SCANport product parameters 1 – 999 (all information — read only)
N31:1 – 999 SCANport product parameters 1000 – 1999 (all information — read
only)
N32:1 – 999 SCANport product parameters 2000 – 2999 (all information — read
only)
N33:1 – 999 SCANport adapter parameters 1 – 999 (all information — read only)
N40:0 – 63 Block Transfer Emulation file
N42:5 1203-Gx2 Firmware Emulation Version — The firmware version of the
1203-Gx2 this adapter emulates for DriveTools compatibility.
N42:6 Max Network Node — The maximum DeviceNet Node Number
N42:7 Adapter Port # — The SCANport adapter port number the adapter is
connected to on the SCANport product
N42:8 Reserved for future use — Always zero