Rockwell Automation 1336-GM6 Enhanced DeviceNet Communications Module User Manual
Page 20

1-8
Overview
•
A PC that is:
–
Running RSNetWorx for DeviceNet.
–
Connected to and communicating with the DeviceNet
network using a 1784-PCD card or a 1770-KFD adapter.
–
Running RS Linx.
–
Running RSLogix5 (if using PLC) or RSLogix500 (if using
SLC).
Important: Refer to http://www.software.rockwell.com for more
information on these software products.
1336-GM6 Board
To install and configure a 1336-GM6 board, you need the following:
•
Enhanced DeviceNet communications board (1336-GM6).
•
A kit that includes one grounding wrist strap, four Phillips
mounting screws, four stand-off nylon headers, one 5-pin
connector and one snap-in comm housing with mounting
instructions (supplied with board).
•
#1 Phillips screwdriver.
•
Appropriate cable for the DeviceNet connection. Refer to the
Selecting Cables section in Chapter 2, Installation.
•
A PC that is:
–
Running RSNetWorx for DeviceNet.
–
Connected to and communicating with the DeviceNet
network using a 1784-PCD card or a 1770-KFD adapter.
–
Running RS Linx.
–
Running RSLogix5 (if using PLC) or RSLogix500 (if using
SLC).
Important: Refer to http://www.software.rockwell.com for more
information on these software products.