Rockwell Automation 1336-GM6 Enhanced DeviceNet Communications Module - Manual (Page 103)

Enhanced DeviceNet Adapter’s Parameters B-15
35 Peer Inp Time-out 0.01-180.00 sec 10.00 Yes No Determines the time out time. If the adapter
does not receive input from the peer node in this
amount of time, it will do what is selected in
Peer Flt Action (33) parameter.
36 Peer Inp Enable Off, On Off Yes No Off = Disables peer input communications.
On = Enables peer input communications.
37 Peer Inp Status Off
Waiting
Running
Faulted
NA No No Displays the status of the consumed peer input
connection.
38 Peer A Output Off
Cmd/Ref
DL A Input
DL B Input
DL C Input
DL D Input
DL A Output
DL B Output
DL C Output
DL D Output
Off Yes No Determines the source of peer A output data in
the SCANport product.
Important: This parameter cannot be changed
when the Peer Out Enable (40) parameter is
On.
39 Peer B Output Off
Cmd/Ref
DL A Input
DL B Input
DL C Input
DL D Input
DL A Output
DL B Output
DL C Output
DL D Output
Off Yes No Determines the source of peer B output data in
the SCANport product.
Important: This parameter cannot be changed
when the Peer Out Enable (40) parameter is
On.
40 Peer Out Enable On, Off Off Yes No Off = Disables peer output communications.
On = Enables peer output communications.
41 Peer Out Time 0.01 – 10.00 1.00 Yes No Determines the minimum interval of time
between peer transmissions.
42 Peer Out Skip 1 – 16 1 Yes No Determines the maximum interval of time
between peer transmissions by multiplying this
value by the value in the Peer Out Time (41)
parameter.
# Name
Valid Values/
Settings
Default Writable
Reset or
Power Cycle
Description
Important: For information on accessing and editing parameters, refer to Chapter 3, Configuring the 1203-GU6 Using a Serial
Connection, or Chapter 4, Configuring the 1203-GU6 or 1336-GM6 Adapter Using RSNetWorx for DeviceNet.