Overview of setting up the adapter, Required tools and equipment – Rockwell Automation 1336-GM6 Enhanced DeviceNet Communications Module User Manual
Page 19
Overview
1-7
Overview of Setting Up the Adapter
To set up the Enhanced DeviceNet adapter, you must perform the
following tasks:
1. Install the module or mount the board. Refer to Chapter 2,
2. Set the adapter’s node address and configure the adapter’s
parameters. Refer to the following table:
3. Configure a scanner (either PLC or SLC) to communicate with
the Adapter. Refer to Chapter 5, Configuring a Scanner to
Communicate with the Adapter.
4. If necessary, create a ladder logic program to control the
SCANport product. Refer to Chapter 6, Ladder Logic
Programming.
Required Tools and Equipment
The tools and equipment required, depend on if you are using a
1203-GU6 module or 1336-GM6 board.
1203-GU6 Module
To install and configure a 1203-GU6 module, you need the following:
•
Enhanced DeviceNet communications module (1203-GU6).
•
5-pin or 10-pin plug-in connector (supplied with module).
•
35 x 7.5 mm DIN rail A (Allen-Bradley part number 199-DR1;
46277-3; EN 50022).
•
1/8" flathead screwdriver.
•
Appropriate cables for SCANport and DeviceNet connections.
Refer to the Selecting Cables section in Chapter 2, Installation.
•
A 1203-SFC serial cable.
•
A PC running either a Windows terminal emulation program
(e.g., HyperTerminal) or a VT100-compatible terminal.
If using:
Then refer to:
1203-GU6 module’s serial connection
Enhanced DeviceNet Module Using a
Serial Connection
1203-GU6 module’s DeviceNet connection
DeviceNet Adapter Using RSNetWorx for
DeviceNet
1336-GM board