Rockwell Automation 1336-GM6 Enhanced DeviceNet Communications Module - Manual (Page 21)

Chapter
2
Installation
Chapter Objectives Chapter 2 provides the information that you need to install the
1203-GU6 module or 1336-GM6 board. In this chapter, you will read
about the following:
• Required tools and equipment.
• Selecting cables.
• Installing the adapter.
• Removing the adapter.
How you install the adapter depends on whether you are installing a
1203-GU6 module or 1336-GM6 board. Refer to the following table
for information:
Installing a 1203-GU6 Module Follow these procedures to install a 1203-GU6 module.
Required Tools and Equipment
To install your 1203-GU6 module, you will need the following tools
and equipment:
• Enhanced DeviceNet communications module (1203-GU6).
• Either a 5-pin or 10-pin plug-in connector (supplied with
module).
• 35 x 7.5 mm DIN rail A (Allen-Bradley part number 199-DR1;
46277-3; EN 50022).
• 1/8" flathead screwdriver.
• Appropriate cables for SCANport and DeviceNet connections.
Refer to the “Selecting Cables” section in this chapter.
Selecting Cables
To connect the 1203-GU6 to the SCANport product and the
DeviceNet network, you must select an appropriate DeviceNet cable
and Allen-Bradley SCANport cable. Use the following information to
select appropriate cables for each connection.
If installing: Then refer to:
1203-GU6 module “Installing a 1203-GU6 Module” on page 1
1336-GM6 board “Installing a 1336-GM6 Board” on page 6