Rockwell Automation 1395 Multi-Comm Hardware/Software - Manual (Page 119)

Chapter 8
Reference
8–24
Parameter 402 – [A>ChA RIO In 3]
Parameter 302 – [B>ChA RIO In 3]
Use: Channel A RIO Input word #3
Parameter Type: Fast Source
Program Terminal Units: None
Minimum Value:
Maximum Value:
Default Value: None
Description: This parameter is a fast source that contains the third word
or group of data from the PLC controller output image table. The data is
transferred to the Drive by the RIO scanner every rack scan. The value
can be used by the MCA board directly or by other Drive functions
through a configuration link.This parameter is displayed for 1/2, 3/4 and
full rack configuration.
Parameter 403 – [A>ChA RIO In 4]
Parameter 303 – [B>ChA RIO In 4]
Use: Channel A RIO Input word #4
Parameter Type: Fast Source
Program Terminal Units: None
Minimum Value:
Maximum Value:
Default Value: None
Description: This parameter is a fast source that contains the fourth word
or group of data from the PLC controller output image table. The data is
transferred to the Drive by the RIO scanner every rack scan. The value
can be used by the MCA board directly or by other Drive functions
through a configuration link. This parameter is only available on channels
that are setup as full or 3/4 racks.
Parameter 404 – [A>ChA RIO In 5]
Parameter 304 – [B>ChA RIO In 5]
Use: Channel A RIO Input word #5
Parameter Type: Fast Source
Program Terminal Units: None
Minimum Value:
Maximum Value:
Default Value: None
Description: This parameter is a fast source that contains the fifth word
or group of data from the PLC controller output image table. The data is
transferred to the Drive by the RIO scanner every rack scan. The value
can be used by the MCA board directly or by other Drive functions
through a configuration link. This parameter is only available on channels
that are setup as full or 3/4 racks.