Rockwell Automation 1408-EMxx PowerMonitor 1000 Unit - Manual (Page 28)

28 Publication 1408-UM001B-EN-P - May 2008
Chapter 4 Explicit Messaging
Message setup is complete for Serial communication.
4. Click the MultiHop tab if configuring Ethernet communication.
5. Enter the IP Address of the power monitor in the first row of the
To Address column.
Message setup is complete.
Serial Communication Command Select the appropriate message type according to
Message Type on page 18 .
Data Table Address Read: This is the controller tag in which to store the data
being read.
Write: This is the controller tag that stores the value to be
written to the power monitor.
Size in Elements This is the number of elements being read or written to. If
you are performing a single element read or write, then
this value should be 1. If you are performing a multiple
element read or write, then this should be the number of
elements after the source element that you wish to read or
write.
Port Number 0
Data Table Address (Target Device) Refer to Appendix A for the address of the specific data
value you’re reading or writing to.
Local Station Address This is the serial node address of your power monitor.
Local / Remote Local
Communication Type Parameter Choice