Opticon PHL 7200 User Manual - Manual (Page 66)

OPTICON
User's manual
PHL-7000 series
3-3
None Disable beep after scanning bar
code.
One Time Beep one time after scanning bar
code (default).
Two Times Beep two times after scanning bar
code.
Select the bar code data transfer method
Disable
Data from bar code reader is
ignored.
Keybd Message
Type
Writing Data from bar code reader is send
as keyboard data to the
application which currently has the
focus (default).
Select the bar code reading mode.
Single
read
When a bar code has been
decoded, the reader will be turned
OFF. The reader must be triggered
again to read another bar code
(default).
Read mode
Multiple
read When a bar code has been
decoded, the reader will stay ON
for the time as set by ‘Read time’
options. The same bar code can
only be decoded again after the
label has not been detected for a
number of scans.
The length of the period that the reader is ON
after the trigger switch is pressed, or (in multiple
read mode), after a label has been read.
0 sec
Reader will stay on as long as the
trigger switch is being pressed.
1 sec 1 second
2 sec 2 seconds (default)
3 sec 3 seconds
4 sec 4 seconds
Read time
5 sec 5 seconds