Item & function, General ” tab ( figure 3-83 ), Firmware information – Opticon PHL 7200 User Manual User Manual
Page 112: Press the “ ok ” key on the keypad, Device name ” tab ( figure 3-85 ), The input panel will open to facilitate data entry, Copyrights ” tab ( figure 3-86 )
OPTICON
User's manual
PHL-7000 series
3-49
3.2.20 System
ICON
ITEM & FUNCTION
•
“General” Tab (Figure 3-83) :
9
To show:
¾
Firmware information
¾
Information about Processor type, Memory size,
Expansion card
•
“Memory” (Figure 3-84) :
9
Move the slider to adjust memory allocation. Default
storage memory is normally set to about 8MB with the
reminder assigned to Program memory.
9
Press the “OK” key on the Keypad.
Note: the difference is occupied by OS between the RAM
size in Information properties and total memory size of
storage memory and program memory
•
“Device Name” Tab (Figure 3-85) :
9
Your device uses this information to identify itself to other
computers.
9
The input panel will open to facilitate data entry.
9
To close the Device Name, press the “OK” button, or press
the <Enter> key on keypad.
•
“Copyrights” Tab (Figure 3-86) :
9
Refer to this tab for specific copyright data. As a user, you
are responsible to read this statement.
Table 3-28 System