Opticon OPN 2002 v35106 Bluetooth OPN2001 simulation Quick Guide User Manual

Opticon Equipment

CAUTION: This information is subject to change without prior notice.

This manual may not, in whole or in part, be copied, photocopied, reproduced, translated or converted to any electronic or
machine readable form without prior written consent of Opticon Sensors Europe.

THE GENERAL USE AND FUNCTIONING OF THE BAR CODE SCANNER IS DESCRIBED IN THIS DOCUMENT. ALSO
GENERAL SETUP INSTRUCTIONS TO GET STARTED ARE DESCRIBED IN THIS DOCUMENT. FOR FURTHER
INSTRUCTIONS CONSULT OPTICON OR YOUR LOCAL DEALER.

OPN2002: OPN2001 SIMULATION BLUETOOTH GUIDE

(Version RFG35106)

The OPN2001 simulation application makes it possible to use OPN2002 as if it's an OPN2001.

Like the OPN2001, the OPN2002 is able to retrieve barcode data and can be configured using its
mini-USB cable. However, the OPN2002 also offers the same functionality using a Bluetooth
connection.

This guide will describe how a Bluetooth connection can be established between your OPN2002 and
remote Bluetooth device like a PC or laptop.

In this manual the OPN2001 PC Application (EGF3094D) will be used to demonstrate how a Bluetooth
connection can be established on a Windows PC.

This application can also downloaded at

www.opticon.com

under:

'Service and support' > 'Software' > 'OPN2002'.

This guide will not describe:

The default OPN2001 compatible operation. Please refer to the OPN2001 documentation for
more information on this subject.

How to develop your own OPN2001 compatible host application. Please download the SDK for the
OPN2001 from our web site for more information.

How to install and use a Bluetooth stack on your remote device. Please check the manual of your
Bluetooth device for more information on this subject.

Loading the application on your OPN2002

All required software to load this application on your OPN2002 can be found on

www.opticon.com

'Service and support' > 'Software' > 'OPN2002'.

To be able to communicate with your OPN2002 using the mini-USB cable, make sure you've installed
the Opticon USB drivers on your PC

Secondly you'll need the latest version of Appload, which is the PC application that can install new
software on the OPN2002.

Make sure you've downloaded and extracted this application on your PC. The file name should have
the following format: 'RBGV02xx_RFG3510x.hex'.

To load this file on your OPN2002 connect it to your PC or laptop using the mini-USB cable. Start
Appload, select the (Virtual) COM port of your OPN2002 and then open the application file in Appload.