Opticon OPN 2002 v35315 Bluetooth demo Quick Guide - Manual

1
CAUTION: This information is subject to change without prior notice.
Copyright 2011, Opticon Sensors Europe BV, all rights reserved.
This manual may not, in whole or in part, be copied, photocopied, reproduced, translated or converted to any
electronic or machine readable form without prior written consent of Opticon Sensors Europe.
THE GENERAL USE AND FUNCTIONING OF THE BAR CODE SCANNER IS DESCRIBED IN THIS
DOCUMENT. ALSO GENERAL SETUP INSTRUCTIONS TO GET STARTED ARE DESCRIBED IN THIS
DOCUMENT. FOR FURTHER INSTRUCTIONS CONSULT OPTICON OR YOUR LOCAL DEALER.
OPN2002 BLUETOOTH DEMO QUICK SETUP GUIDE
(Version RFG35315)
The OPN2002 terminal is supplied with a Bluetooth demo application that demonstrates its
Bluetooth capabilities. Since the OPN2002 terminal does not have a display to display
instructions nor has a keyboard to change the demo application implements a user
interface that consists entirely of using just the 2 keys and reading barcodes. This brief
setup guide describes the features as well as instructions to be able to use this demo
application.
More product details, additional support or configuration options to your own preferences
(by Universal menu book) will be updated at
www.opticon.com
Information about how to install and use a Bluetooth stack on your remote device, like a
PC or mobile device, please check the manual of your Bluetooth device.
Capabilities of the Bluetooth demo application (RFG35315)
The following features are currently supported:
 Connecting to a remote device (as master) and transmit its data using a Bluetooth
virtual COM port (VCP)
 Making the OPN2002 connectable (as slave) and discoverable to allow a remote
device to connect with the OPN2002 and allow the transmission of its data using a
Bluetooth virtual COM port (VCP)
 Making the OPN2002 connectable (as slave) and discoverable as HID (keyboard)
device to allow the remote device to connect with the OPN2002 and transmit its
barcode data as Bluetooth keyboard device.
 Reconnecting to a paired remote device (as master) to quickly re-establish a lost
Bluetooth HID connecting without having to re-enter a PIN code.
 (Limited) Opticon Universal menu book support to configure barcode decoders, pre-
and suffixes, read modes, buzzer/LED settings, change Bluetooth configurations and
switch between HID or VCP as Bluetooth interface.
 Possibility to configure a remote Bluetooth address and PIN code using barcodes
 Use of the trigger and clear key to connect, disconnect, make discoverable /
connectable and reconnect.
 Storing of configurations in non-volatile memory to allow all settings to be restored
after a reset.
 Configuration of the application by using Opticon serial commands
 Easy software upgrading by USB (VCP) or the CRD-2000 multi cradle (RS232) using
Appload.
 iPhone / iPad compatibility