INFICON IQM-233 Thin Film Deposition Controller PCI-Express Card Codeposition Software Operating Manual User Manual
Page 77
2 - 57
IP
N 07
4-
58
5-
P1
A
IQS-233 Operating Manual
Max. Freq (MHz) . . . . . . . . . 4.002000 to 6.100000 MHz
Enter the highest possible frequency of a new
crystal. Frequencies above this value will cause a
Crystal Fail error to occur.
Init. Freq (MHz) . . . . . . . . . . 4.001000 to 6.099000 MHz
Enter the nominal frequency of a new crystal; usually
5 MHz or 6 MHz.
Min. Freq (MHz). . . . . . . . . . 4.000000 to 6.098000 MHz
Enter the lowest desired crystal frequency.
Frequencies below this value will cause a Crystal
Fail error to occur.
NOTE: The Max. Freq value must be at least 0.001
MHz higher than the Init. Freq value, and the
Init. Freq value must be at least 0.001 MHz
higher than the Min. Freq value.
Card Assignment . . . . . . . . Displays the computer Bus, Device, and Command
assignments for up to two installed IQM-233 or
SQM-242 cards. If IQM-233 and SQM-242 cards are
installed, only the Bus, Device, and Command
assignments for up to two IQM-233 cards will be
displayed.
NOTE: SQM-242 cards are not detected if IQM-233
cards are installed.
Card 1 Rev . . . . . . . . . . . . . The firmware revision of the IQM-233 or SQM-242
card automatically interfaced to the
IQS-233 Codeposition software.
Card 2 Rev . . . . . . . . . . . . . The firmware revision of the second card
automatically interfaced to the
IQS-233 Codeposition software if two IQM-233 or
SQM-242 cards are installed.
DLL Return . . . . . . . . . . . . . The firmware version of the installed Dynamic Link
Library (DLL) used by the IQS-233 Codeposition
software.