Eppendorf epMotion 5075 - Manual (Page 88)

Operation
epMotion
® 5075
English (EN)
88
9.1.3 Using the epMotion
The epMotion workflow consists of the following steps.
1. Create an application (refer to the epMotion software operating manual).
2. Equip the worktable (see p. 88).
3. Execute the application (see p. 93).
4. Complete your work (see p. 96).
Step 1 is described in the software operating manual. Steps 2 to 4 are described in the following sections.
9.2 Loading the worktable
To prepare the epMotion for an application, perform the following steps:
• Display the loading in the software
• Positioning tools
• epT.I.P.S. Motion
• Position the waste container
• Position labware
9.2.1 Display the loading
To display the loading of the worktable, proceed as follows.
1. Open the application.
2. Select the area or the Run (refer to the epMotion software operating manual) step.
NOTICE! Tool collisions with incorrectly positioned labware.
Labware must be positioned on the epMotion worktable as defined in the application.
Tools and labware become damaged in a collision. A collision can lead to sample loss.
 Check the positioning of the labware before starting the application.