Eppendorf epMotion 5075 - Manual (Page 38)

Hardware
epMotion
® 5075
English (EN)
38
Tab. 5-1: Temperature control duration for labware with thermal module
This information applies at an ambient temperature of 25 °C for the border positions in the labware. The
thermal modules were tempered at the target temperature before the labware was positioned.
5.3.3 Equipping the thermal module
When you use a thermoblock or thermoadapter, plates with uneven bases will be optimally tempered, e.g.,
PCR plates.
Equip the thermal module as follows:
1. Place the plate on the thermoadapter or thermoblock.
2. Place the plate, with thermoadapter or thermoblock, on the thermal module.
Labware on the 
thermal module Water filling
volume per well
in μL Cooling from 
25°C to 4°C Heating from 
25°C to 37°C Heating from 
25°C to 95°C
Temperature
setting in °C min Temperature
setting in °C
min Temperature
setting in °C
min
Thermal module 
without labware 5 2 8
Thermoadapter with
96-well twin.tec 
PCR plate skirted 50 3 7 38 5 104 11
Thermoblock with 96-well
twin.tec PCR plate skirted 50 3 6 37 4 101 10
Thermoadapter with
384-well twin.tec 
PCR plate skirted 10 3 5 37 5 103 8
Thermoblock with
384-well twin.tec 
PCR plate skirted 10 3 5 37 5 98 7
24-unit thermorack with
0.5 mL Safe-Lock tubes 350 3 24 37 16 101 35
24-unit thermorack with
1.5 mL Safe-Lock tubes 1200 3 30 38 18 104 44
24-unit thermorack with
2.0 mL Safe-Lock tubes 1700 3 25 37 17 100 40
Information on setting the thermal module and a detailed description of all functions can be
found in the "Operation" chapter of the software instructions.