Eppendorf epMotion 5075 - Manual (Page 80)

Labware accessories
epMotion
® 5075
English (EN)
80
8.2 Adapters
The following adapters are available for the epMotion:
• Height adapter
• Thermoadapter
8.2.1 Height adapter
Abb. 8-13: Height adapter
Fig. 8-13: Height adapter
The height adapters are used to offset the various heights of the labware. The tool holder does not need to
offset these height differences and remains at one height. The shorter paths of this tool holder allows the
application to run more quickly.
The height of the adapter is listed on the adapter. The combined height of the labware and the adapter may
not exceed 126 mm.
Height adapters are not transported with the gripper.
Tab. 8-3: Available height adapters
Adapters Use with
40 mm • epT.I.P.S. Motion racks 50 μL and 300 μL in size
55 mm • DWP plates
• 400 mL reservoirs
• Thermoblock with PCR plates
85 mm • Almost all MTP plates with 6 – 384 wells
• Almost all PCR plates with 96 and 384 wells
• PCR thermoblock with PCR plates