Eppendorf epMotion 5075 - Manual (Page 46)

Hardware
epMotion
® 5075
English (EN)
46
5.6.6 Loading the vacuum unit
Load the vacuum unit as follows:
1. Place the collection vessel on the vacuum unit.
2. If applicable, place channeling plate 96 on the collection vessel.
3. Place the vacuum frame on the collection vessel.
The weight of the vacuum frame presses the collection vessel into the vacuum unit.
4. Place the filter plate in the vacuum frame.
5. If applicable, place the VAC Lid or the VAC Thermo Lid on the filter plate.
The label on the VAC Lid and the Vac Thermo Lid must face the front
6. The VAC Lid and Vac Thermo Lid can be transported during the application. For the transport, place the
VAC Lid on the gripper holder and the VAC Thermo Lid on a thermal module.
1 VAC Lid
2 Filter plate
3 Vacuum frame
4 Collection vessel
5 Vacuum unit
If the vacuum frame is incorrectly positioned, the vacuum will not be generated.
1
2
3
4
5