SkyTrak 6036 Service Manual - Manual (Page 99)

4-5 6036, 6042, 8042, 10042, 10054
Cab and Covers
5. Remove the lower dash panel.
6. Remove the two capscrews, four flat washers, two
pivots and two nuts securing the service brake pedal
to the cab.
7. Remove the service brake pedal from the cab.
d. Service Brake Pedal Installation
1. Position the service brake pedal in its mounting
location within the cab.
2. Insert the two brake pedal pivots into mounting
locations on the service brake pedal.
3. Install the service brake pedal with the previously
used hardware.
4. Be sure the brake pedal has the correct range of motion.
Secure pivot pin with bolt and lockwasher.
5. Adjust the service brake as needed. Refer to Section
9.10.5, c. “Service Brake Switch Adjustment.”
6. Install the lower dash panel.
7. Properly connect the battery.
8. Remove the Do Not Operate Tags from both the
ignition key switch and the steering wheel.
9. Close and secure the rear door.
4.3.3 Throttle Pedal
a. Throttle Pedal Removal
1. Park the machine on a firm, level surface, level the
machine, fully retract the boom, lower the boom,
place the travel select lever in the (N) NEUTRAL
position, engage the parking brake and turn the
engine OFF.
2. Place a Do Not Operate Tag on both the ignition key
switch and steering wheel, stating that the machine
should not be operated.
3. Properly disconnect the battery.
4. Disconnect the electrical harness connector (4).
5. Remove the bolts (5) securing the throttle pedal to
the throttle pedal bracket (6).
6. Remove the throttle pedal assembly from the cab.
b. Throttle Pedal Installation
1. Position the throttle pedal in its mounting location
within the cab.
2. Secure the throttle pedal in place with previously
used hardware.
3. Reconnect the wire harness plug to the front of the
throttle pedal.
4. Properly connect the battery.
5. Remove the Do Not Operate Tags from both the
ignition key switch and the steering wheel.
MH6210
MH6240
4
5
6