SkyTrak 6036 Service Manual - Manual (Page 132)

Transmission
6-6 6036, 6042, 8042, 10042, 10054
12. Uncap and connect the previously labeled
transmission oil cooler inlet and out hoses at the
transmission.
13. Install the hydraulic pump. Refer to Section 8.6.1,
“Pump Replacement.”
14. Install the engine-to-transmission and transmission-
to-axle drive shafts. Refer to Section 5.8.5, “Drive
Shaft Installation.”
15. Clean the transmission oil filter mounting surface.
16. Apply a thin film of clean Mobilfluid 424 ®
(ISO Grade 46) to the new transmission filter gasket.
Install the new filter and torque to 20-25 lb-ft
(27-34 Nm).
17. Transmission oil may be added through the dipstick
tube. Remove the dipstick and add Mobilfluid 424 ®
(ISO Grade 46). Check the oil level by taking
intermittent dipstick readings as outlined in the
appropriate Operation & Safety Manual. DO NOT
overfill. Reinstall the dipstick when finished.
18. Install the transmission covers.
19. Properly connect the battery.
20. Remove the Do Not Operate Tags from both the
ignition key switch and the steering wheel.
21. Close and secure the rear door.
6.4.4 After Transmission Service or
Replacement
In general:
1. Check the transmission oil level and add oil as
required.
2. Install a new transmission filter.
3. Check the torque on the drive shaft yoke capscrews.
4. When an overhauled or repaired transmission is
installed, thoroughly clean the oil cooler lines to and
from the transmission.
5. Drain and flush the entire system.
6. Disconnect and clean all transmission cooler hoses.
When possible, remove transmission lines from the
machine for cleaning.
7. Thoroughly clean transmission filter screens and
cases, and replace transmission filter elements.
8. Reassemble all components and fill the transmission
with clean, fresh Mobilfluid 424 ® (ISO Grade 46)
through the dipstick tube opening (8). Check the
level by taking intermittent dipstick readings as
outlined in the appropriate Operation & Safety
Manual. DO NOT overfill. Reinstall the dipstick when
finished.
9. Run the engine for two minutes at idle to help prime the
torque converter and the transmission oil lines.
10. Recheck the level of the fluid in the transmission with
the engine running at idle.
11. Add Mobilfluid 424 ® (ISO Grade 46) as necessary to
bring the fluid level up until it reaches the FULL mark
on the dipstick. Recheck the oil level when it reaches
operating temperature 180-200° F (83-94° C).
12. Recheck all drain plugs, lines, connections, etc., for
leaks, and tighten where necessary.
MH6300
8