SkyTrak 6036 Service Manual - Manual (Page 237)

10-9 6036, 6042, 8042, 10042, 10054
Stabil-TRAK™ System and Boom Interlock System
b. Removal
1. Park the machine on a firm, level surface, level the
machine, fully retract the boom, lower the boom,
place the travel select lever in the (N) NEUTRAL
position, engage the parking brake, straighten all
wheels and shut the engine OFF.
2. Lower the outriggers onto firm terrain, and shut the
engine OFF.
3. Place a Do Not Operate Tag on both the ignition key
switch and steering wheel, stating that the machine
should not be operated.
4. Open the rear door. Allow the system fluids to cool.
5. Properly disconnect the battery.
6. Disconnect the pressure switch wiring connector
(18) from the harness connector (19)
7. Remove the outrigger pressure switch (20) from the
outrigger cylinder.
8. Wipe up any spilled hydraulic oil.
c. Installation
1. Install pressure switch (20), and torque to 25–38 lb-ft
(34–41 Nm).
2. Connect the pressure switch wiring connector (18) to
the harness connector (19).
3. Properly connect the battery.
4. Close and secure rear engine compartment door.
5. Remove the Do Not Operate Tags from both the
ignition key switch and the steering wheel.
10.5 BOOM EXTEND INTERLOCK
SYSTEM DESCRIPTION
Note: The boom interlock system is used only on the
Model 10054.
Boom extend interlock system is designed to provide
additional stability, allowing boom to be extended to its
maximum limits. Appropriate Operation and Safety
Manual contains boom extend interlock basic
information. A copy of Operation and Safety Manual
should always be available in storage compartment
located in cab.
The interlock system operates via an interface between the
outrigger pressure switches (1), boom extend sensor (2),
boom lockout valve (3) and the logic wiring harness.
Boom extend interlock system can only be activated
when both outriggers are lowered onto firm terrain. Once
boom extend interlock system has been activated,
vehicle will automatically place Stabil-TRAK™
system in
LOCKED MODE. The Stabil-TRAK™ system will remain
in LOCKED MODE, until boom has been retracted.
(Refer to Section 10.4, “Stabil-TRAK™
Operation,” for
more information.)
MH4131
20
2
MH2950
1
MH4100
~
3