beautypg.com

3 after fuel system service, After fuel system service – SkyTrak 6036 Service Manual User Manual

Page 143

background image

7-7

6036, 6042, 8042, 10042, 10054

Engine

f.

Fuel/Hydraulic Oil Tank Installation

1. Attach tank to a suitable lifting device at lift point.

2. Place tank carriage bolts into slotted holes in frame.

3. Position the tank and insert carriage bolts through

tank attachment holes. Install lockwashers and
finger tighten nuts onto carriage bolts. Slide the tank
and carriage bolts toward the front of machine, until
carriage bolts are bottomed out into the slotted
frame holes.

4. Connect the previously labeled electrical

components to the tank.

5. Uncap and connect the previously labeled hydraulic

hoses to their appropriate locations.

6. Fill the tank according to specifications. Refer to

Section 2.5, “Fluid Specifications.”

7. Check tank for leaks.

8. Install the two frame top covers.

9. Install the fuel/hydraulic oil tank cover.

10. Properly connect the battery.

11. Remove the Do Not Operate Tags from both the

ignition key switch and the steering wheel.

12. Close and secure the rear door.

7.6.3

After Fuel System Service

1. Drain and flush the fuel tank if it was contaminated.

2. Vent air from the fuel system in accordance with the

instructions found in the appropriate Operator &
Safety Manual.

3. Fill the fuel tank with fresh, clean diesel fuel as

required.

This manual is related to the following products: