SkyTrak 6036 Service Manual User Manual
Page 117
5-11
6036, 6042, 8042, 10042, 10054
Axles, Drive Shafts, Wheels and Tires
1. Park the machine on a firm, level surface, level the
machine, fully retract the boom, lower the boom,
place the travel select lever in the (N) NEUTRAL
position, engage the parking brake, straighten all
wheels and shut the engine OFF.
2. Place a Do Not Operate Tag on both the ignition key
switch and steering wheel, stating that the machine
should not be operated.
3. Open the rear door. Allow the system fluids to cool.
4. Properly disconnect the battery.
5. Remove the fender assembly (if equipped).
6. Models 10042 and 10054, Front Axle Only: Remove
outrigger assembly. Refer to Section 5.6.6, a.
“Outrigger Removal (10042 & 10054 only).”
7. If axle will be disassembled after removal, place a
suitable receptacle under axle drain plug (1).
Remove drain plug and allow axle oil to drain into
receptacle. Transfer used axle oil into a suitable
covered container, and label container as “Used Oil.”
Dispose of used oil at an approved recycling facility.
8. Label, disconnect and cap the steering and brake
lines at the axle. Cap all fittings to prevent dirt and
debris from entering the hydraulic system. Wipe up
any spilled oil.
9. Block the front and rear of both tires on the axle that
is not being removed. Ensure that the machine will
remain in place during axle removal before
proceeding.
10. Raise the machine using a suitable jack or hoist.
Place suitable supports under both sides of the
frame and lower the machine onto the supports.
Ensure that the machine will remain in place during
axle removal.
11. Support the axle that is being removed with a suitable
jack, hoist or overhead crane and sling. DO NOT
raise the axle or the machine.
12. Remove both wheel and tire assemblies from the
axle that is being removed. (Refer to Section 5.9.1,
“Removing Wheel and Tire Assembly from
Machine.”)
Note: The wheel and tire assemblies must be re-installed
later with the directional tread pattern “arrows” facing in
the direction of forward travel.
13. Remove the drive shaft assembly. Refer to Section
14. Remove the capscrew and locknut securing the
lower position cylinder-mount pin (2) to the cylinder.
Tap the cylinder mount pin out, and move the
cylinder to prevent it from interfering with axle
removal.
15. Remove the capscrew and locknut securing the axle
pivot pin (3) to the frame.
Note: Record the number and location of shims (4) to
ensure correct installation.
16. Remove the pivot pin and shims.
17. Remove the axles from the machine using the jack,
hoist or overhead crane and sling supporting the
axle. DO NOT raise or otherwise disturb the machine
while removing the axle. Balance the axle and
prevent it from tipping, turning or falling while
MAQ0960
1
MAQ0980
2
2
3
3
4
4