SkyTrak 6036 Service Manual - Manual (Page 151)

7-15 6036, 6042, 8042, 10042, 10054
Engine
4. Install the access cover plate over the drive shaft
and assemble the drive shaft flange to the coupler
using new hardware. Torque to 48 lb-ft (65 Nm).
5. If engine mounts were previously removed or
loosened, carefully lower the engine down onto the
front engine mounts. Reassemble the rebound
washer and secure in place with a new locknut.
Torque to 60 lb-ft (81 Nm). Repeat this procedure for
the engine mount on the other side.
6. Thoroughly clean the transmission yoke and secure
in place with new straps and hardware. Torque to
55–60 lb-ft (75–81 Nm).
7. After the drive shaft is in place, grease both u-joints
and the slip joint using multi-purpose grease.
8. Properly connect the battery.
9. Close and secure the rear door.
10. Remove the Do Not Operate Tags from both the
ignition key switch and the steering wheel.